 Ford Connect Van Security
 Installation photographs from our full-colour instruction book are shown below. The kit also includes step-by-step instructions and a schematic wiring diagram.
For other support questions, please e-mail us.
(FWA 0060)
| Under the Bonnet | 1. Pin Switch Location | 2. Pin Switch Installed |  |  | | | 3. Mounting the Siren 
|
Inside the Van — Installing the LED on the Door Trims | 4. Use the template to position the LED | 5. LED fitted on top edge of door trim |  Passenger door shown |  | | | | 6. Running the Cable to the Flashing LED 
|
Mounting the Sensors | 7. Removable Panel at Left End
of Dashboard | 8. Sensor Fitted |  |  | 9. Mount the Valet Button on the Centre Console. 
|
| 10. Behind the Glove Box | 11. Location of Ford CDL Module |  |  Shown with Fuse Box lowered |
| 12. Connection to the Ford CDL Module | | Factory Harness |  | Remove Factory Harness and Plug in Green Connector from Wolf Harness |
| 13. Passenger Side Kick Panel | 14. Fit Grey Connectors from Wolf Harness |  |  |
The alarm is now ready for testing! | 
